Phau Ntawv Qhia

11
Flame Effect
R4 Press
to enter the flame effect adjustment
screen.
R5 Press the ‘←’ and ‘→’ button to select the 3
kinds of flame effect.
R6 Press the ‘+’ and ‘-’ button to select the 5
brightness levels of the flame effect and OFF
settings
Mood Light
R7 Press
to enter the mood light adjustment
screen.
R8 Press the ‘←’ and ‘→’ button to cycle through
the 13 colours of mood light or a colour-cycle
mode.
R9 Press the ‘+’ and ‘-’ button to to select the 5
brightness of mood light and OFF settings
Normal Mode
R10 Normal control mode is factory set. If it is not,
then press
button until the logo shows
up at the upper right corner of the screen.
R11 Press the ‘+’ and ‘-’ button to adjust the
temperature setting from 17℃ to 25℃ by 2
℃ intervals
R12 Press
button to turn on/off heat,
ON、 OFF will show at the lower of the
screen.
NOTE: It is normal for the fan heater to stop running for periods of time. This
happens because the room temperature is at or above the temperature set on
the remote control. The heater indicator will be turned off after 10s if you have
the flame ON. The heater indicator will stay ON if you use the heating function
only.