User`s manual

78
MP-4200 TH Programmer’s Manual - Revision 1.0
Bit Off/On Hex Decimal Function
0 Off 00 0 Two-byte character code not supported.
On 01 1 Two-byte character code supported.
1 On 02 2 Auto-cutter equipped.
2 Off 00 0 Not used. Fixed to off.
3 Off 00 0 Not used. Fixed to off.
4 Off 00 0 Not used. Fixed to off.
5 - - - Undefined.
6 - - - Undefined.
7 Off 00 0 Not used. Fixed to off.
[Details]  •WhenDTR/DSRcontrolisselectedintheserialinterfacemodel,theprintertransmitsprinter
    IDafterconfirmingthatthehostisreadytoreceivedata.
•WhenXON/XOFFcontrolisselectedintheserialinterfacemodel,theprintertransmitsthe
printerIDwithoutconfirmingtheconditionoftheDSRsignal.
•  The printer ID is transmitted when command bytes are processed in the receive buffer.
Therefore, there may be a time gap between receiving this command and transmitting the
status, depending on the receive buffer status.
•WhenprinterIDtransmissionisspecifiedwith(1≤n≤3)or(49≤n≤51),onebytecode
is transmitted.
•WhenAutoStatusBack(ASB)isenabledusingGSa,theprinterIDtransmittedbyGSIand
the ASB status must be differentiated.
•WhenprinterIDisspecifiedwith(65≤n≤69),the[Header+Data+NUL]contentsis
transmitted, where:
oHeader:Hexadecimal=5Fh/Decimal=95(1byte)
oData:Printerinformation
oNUL:Hexadecimal=00h/Decimal=0(1byte)
GS L n
L
n
H
[Function] Set left margin.
[Format]  ASCII   GSLn
L
n
H
    Hexadecimal  1D4Cn
L
n
H
    Decimal  2979n
L
n
H
[Range]  0≤n
L
≤255
    0≤n
H
≤255
[Default]  nL=0,n
H
=0
[Description] Setleftmarginusingn
L
and n
H
.
    •Theleftmarginissetto[(n
L
+n
H
×256)×horizontalmotionunit)]inches.
[Details]  •Thiscommandiseffectiveonlywhenprocessedatthebeginningofaline.
•Ifsettingsexceedprintablearea,themaximumvalueoftheprintableareaisused.
•ThehorizontalandverticalmotionunitsarespecifiedbyGSP.Changingthehorizontaland
vertical motion unit does not affect the current left margin.