User`s manual

58
MP-4200 TH Programmer’s Manual - Revision 1.0
•Thedownloadedbitimagedefinitionisclearedwhen:
oESC@isexecuted.
o FS q is executed.
o Printer is reset or the power is turned off.
•Thefollowingfigureshowstherelationshipbetweendownloadedbitimageandprintdata:
Reference]  GS/
GS / m
[Function] Print downloaded bit image.
[Format]  ASCII   GS/m
    Hexadecimal  1D2Fm
    Decimal  2947m
[Range]  0≤m≤3,48≤m≤51
[Description] Printdownloadedbitimageusingthemodespecifiedbym.
m Mode Vertical Dot Density Horizontal Dot Density
0, 48 Normal 203dpi 203dpi
1,49 Double-width 203dpi 101 dpi
2, 50 Double-height 101 dpi 203dpi
3,51 Quadruple 101 dpi 101 dpi
[Details]  •Thiscommandisignoredifadownloadedbitimagehasnotbeendefined.
•Thiscommandiseffectiveonlywhenthereisnodataintheprintbuffer.
•Thiscommandhasnoeffectinprintmodes(emphasized,double-strike,underline,character
size, or white/black reverse printing), except for upside-down printing mode.
•Ifdownloadedbit-imageexceedstheprintablearea,theexcessdataisnotprinted.
•IftheprintingareawidthsetbyGSLandGSWislessthanonelineinvertical,thefollowing
processing is performed only on the line in question:
o The printing area width is extended to the right up to one line in vertical. In this case,
printing does not exceed the printable area.
o If the printing area width cannot be extended by one line in vertical, the left margin
is reduced to accommodate one line in vertical.
[Reference]  GS*