User`s manual

51
MP-4200 TH Programmer’s Manual - Revision 1.0
interfaces.
•Sensorisswitchedduringcommandexecution.Thepaperendsignalswitchingmaybedelayed
depending on the receive buffer state.
•Ifeitherbit0orbit1ison,thepaperrollnear-endsensorisselectedasthepapersensor
outputting paper-end signals.
•Ifeitherbit2orbit3ison,thepaperrollendsensorisselectedasthepapersensoroutputting
paper-end signals.
•Whenbothsensorsaredisabled,thepaperendsignalalwaysoutputsapaperpresentstatus.
ESC c 4 n
[Function] Select paper sensor(s) to stop printing.
[Format]  ASCII   ESCc4n
    Hexadecimal  1B6334n
    Decimal  279952n
[Range]  0≤n≤255
[Default]  n=0
[Description] Selectpapersensor(s)usedtostopprintingwhenapaper-endisdetected,usingnasfollows:
Bit Off/On Hex Decimal Function
0
Off 00 0 Paper roll near-end sensor disabled.
On 01 1 Paper roll near-end sensor enabled.
1
Off 00 0 Paper roll near-end sensor disabled.
On 02 2 Paper roll near-end sensor enabled.
2-7 - - - Undefined.
[Details]  •  When a paper sensor is enabled with this command, printing is stopped only when the
corresponding paper is selected for printing.
•Whenapaper-endisdetectedbythesensor,theprintergoesofflineandstopsprinting.
•Wheneitherbit0or1ison,theprinterselectsthepaperrollnear-endsensorforthepaper
sensor to stop printing.