User`s manual

50
MP-4200 TH Programmer’s Manual - Revision 1.0
•Theprintstartingpositionmovesfromcurrentpositionto[N×horizontalmotionunit].
•ThehorizontalmotionunitcanbespecifiedbyGSP.
•TheGSPcommandcanchangethehorizontalmotionunit.However,thevaluecannotbeless
than the minimum horizontal movement amount, and it must set be in even units of the minimum
horizontal movement amount.
[References] ESC$,GSP
ESC a n
[Function] Select justification.
[Format]  ASCII   ESCan
    Hexadecimal  1B61n
    Decimal  2797n
[Range]  0≤n≤2;48≤n≤50
[Default]  n=0
[Description] Aligndatainonelinetothespecifiedposition.nselectsthejustificationasfollows:
n Justification
0, 48 Leftjustification.
1,49 Centering.
2, 50 Right justification.
[Details]  •Thecommandisenabledonlywhenprocessedatthebeginningofaline.
•Thiscommandexecutesjustificationintheprintingarea.
•ThiscommandjustifiesthespaceareaaccordingtoHT,ESC$orESC\.
ESC c 3 n
[Function] Select paper sensor(s) to output paper end signals.
[Format]  ASCII   ESCc3n
    Hexadecimal  1B6333n
    Decimal  279951n
[Range]  0≤n≤255
[Default]  n=15
[Description] Selectsthepapersensor(s)tooutputpaperendsignals,usingeachbitofnasfollows:
Bit Off/On Hex Decimal Function
0
Off 00 0 Paper roll near-end sensor disabled
On 01 1 Paper roll near-end sensor enabled
1
Off 00 0 Paper roll near-end sensor disabled
On 02 2 Paper roll near-end sensor enabled
2
Off 00 0 Paper roll end sensor disabled
On 04 4 Paper roll end sensor enabled
3
Off 00 0 Paper roll end sensor disabled
On 08 8 Paper roll end sensor enabled
4-7 - - - Undefined
[Details]  •Itispossibletoselectmultiplesensorstooutputsignal.Then,ifanyofthesensorsdetectsapaper
end, the paper end signal is output.
•Thecommandisavailableonlywithaparallelinterfaceprinter,anditisignoredwithother