User manual

8 9

The charging indicator on the Boom Box will light up while charging

It will take about 10 hours to fully charge the Boom Box

Charging Indicator Light Modes

• Red LED / Flashing Fast: Battery is low, charge the unit soon.

• Red LED / Flashing Slow: Boom Box is charging

• Green LED: Battery is fully charged

Note: if the unit has not been used in the past 7 days please charge

for 10 minutes before using the Boom Box.

Operation Details (cont.)

Troubleshooting

Issue: Pairing is unsuccessfully after multiple attempts

Solution:

• Check if the Bluetooth© indicator light is on. If the indicator

light is off, please slide the power switch to turn the unit on.

If the Bluetooth© indicator light still doesn’t come on after

sliding the power switch, please charge the unit.

• Check for other Bluetooth© devices around the surroundings

that may interfere with searching and turn devices off.

• Power off and then power on the unit to restart the Bluetooth©

function of the unit or your Bluetooth device

• Unplug any cables plugged into the AUX IN, restart all devices

and then attempt pairing again.

Issue: Interference or static during playback

Solution:

• Make sure the working distance is approximately 25 ft.

• Avoid using the device between concrete or other building

structures that may interfere with the signal.

device and charge if necessary.

For more troubleshooting help go to http://bemwireless.com

Battery level detection

Press “Volume -“ and “Volume +” together at the same time to enter

the indicator working mode:

4 LEDs turn on : the balance battery 76%-100%

3 LEDs turn on : the balance battery 51%-75%

2 LEDs turn on : the balance battery 26%-50%

1 LED turns on : the balance battery 1%-25%, the user should charge

the unit soon.