Instructions / Assembly

Connection
Laptop / notebook / PC
As the Bluetooth© versions for these types of devices varies
greatly, the connection methods will differ as well. If you can
not connect with the Party Block using the previous method
instructed you may need to install a new version of the
Bluetooth© driver.
Please reference the instructions of your device for details.
Speaker Placement
The Sender unit has built-in battery and is portable. This allows the
perfect placement of the sender unit for maximum distance.
The speaker can be set anywhere you like. Approximate maximum
range is 50 feet from the Sender unit (open area) to the individual
Party Block units. The Party Block uses 5.8gHz signal so you’re
free to put the speakers where you like!
Charging
Connect your Party Block Sender to an outlet using the included
5V,2A power adapter. It will start charging the Sender unit.
The power indicator will flash slowly during charging and goes out
when it has reached a complete charge (Approx. 3.5 hours).
Connect the Satellite Speaker to an outlet using the included
12V,2A power adapter. The power indicator on speaker will
flash slowly during charging and goes out when it has reached a
complete charge (Approx. 4 hours).
Charging Your Device
The sender features a standard USB charging port with 5V,1A
output at the back which can charge most cell phone and tablet,
Please reference the instructions of device for details.
The charging cable is not included.
Using the Device Stand
Slide the sender open to use the device stand. The back rest
was designed to tilt your device at a 25 degree angle for
optimal viewing.
Adding Additional Speakers
You can run up to 99 Party Blocks off of 1 sender. Just power on
Party Block speakers within range of the sender.
Weather Resistance
Your Party Block speaker has an IP44 rating against particles (dust)
and water. This standard in the industry helps to define the products
resistance to particles and liquids. At this rating your Party Block
is protected against solid bodies larger than 1mm and against
projections of water from all directions.
Follow these steps to pair your Party Block to another Party
Block Sender:
1. Turn on the power to the Sender
2. Hold the power button on the sender for 2 seconds
3. Once the RF LED light begins to flash quickly, turn on the
Party Block speaker and it will then connect to the Sender
Note: If the Satellite Speaker or Sender unit has not used for
7 days, please charge for a minimum of 30 minutes before use.
10 11