Instructions / Assembly

Operation Details
Power on / Power off
Sender: Press the power button to turn on the Sender unit of Party
Block. The Bluetooth indicator will light up to signify the unit is
on and ready to be paired. Press the power button again to turn
off the base and the Bluetooth indicator light will go out.
Satellite Speakers: Press the power button to turn the speaker
on. The indicator light on the speaker will light up to signify the unit is
on. Press the power button again to turn off the speaker and the
Indicator will also go out.
Step 2: Connect it (continued)
Next time the Party Block and connected device will pair
automatically. After completing this step you are ready to start
playing audio from your connected device.
Holding the Power button for 5 seconds will disconnect the
connected device and enter pairing mode for pairing a
new device.
Direct Connection
The Party Block can also be connected to any device that has a
headphone jack or line out using the included aux cable.
Play modes
• Bluetooth mode: plays an audio signal from the connected
Bluetooth
©
device.
• AUX mode: plays an audio signal from the connected
“wired” device.
Please note, the Bluetooth has the priority to play, if an Aux cable is connected to
the speaker, please turn off the Bluetooth© music or disconnect Bluetooth device
first for playing an audio signal from AUX.
Audio Use
Follow the above connection steps to pair a Bluetooth
©
device
with the Party Block. At this point you can send any kind of audio
signal to your speaker (music, video, gaming, etc.). Just use your
device as normal and the audio will play through your Party Block
Controls on the Speaker
• Press Light on/off to turn on or off the LED light feature.
• Press Light Mode to shift among 3 color (Red, Green,
White),Lighting mode (warm white) and color change
• Press Music Sensor on/off to turn on/off the music sensor,
when the music is on, the light will flash following the pace of
playing music.
• Pressing the + and - buttons will increase or decrease the
volume on the Party Block. Please note that this will not
affect the volume levels on the connected device.
Operation Details (cont.)
Please note, always make sure to first turn on the Sender unit
before turning on the speaker.
8 9