N O R T H A M E R I C A BELTRONICS 5442 West Chester Road West Chester OH 45069 Service 800.341.2288 www.beltronics.com ©2013 BELTRONICS. Beltronics, STiR Plus, TotalShield Technology and AutoScan are registered trademarks of Beltronics USA. SWS is a trademark of SWS LC. Features, specifications and prices subject to change without notice.
STiR PLUS Comes Complete Front Radar Receiver • Miniature weatherproof radar receiver • Two universal mounting brackets with stainless steel hardware • Built-in 3-foot cable with waterproof connector • 13-foot cable with waterproof connector and inline grommet • 12 nylon wire ties to secure cable GPS Antenna • Weatherproof magnetically mounted GPS Antenna • 30-foot cable with modular connector • Interior windshield mounting bracket included Display Module • Display mounts easily to instrument pod, dashboa
Important Notes Read This First Installation Instructions Important Installation Warnings For the easiest, trouble-free installation, install the interface first and wire it to a 12-volt switched circuit. 1 It is recommended that you have a professional install your new STiR PLUS. Installation of this system requires experience and expertise in automotive electronics. If you are unfamiliar with automotive electronics, car audio specialists and many car dealers can install your STiR PLUS for you.
A B Interface 1 Install the Interface under the dash using supplied zip-ties. Note: Do Not Mount In Engine Compartment. 2 Connect black wire (-) to ground, and red-striped wire (+) to a switched 12-volt supply. (If STiR PLUS is left in the “on” position, it will automatically power on and off with the ignition). Use blue 3M connector (provided) to tap into an existing circuit if needed.
Installation Schematic Overview Letter References For Components (Color Coded Connections To Interface) A Interface B Front Radar Receiver (White Stripe) C Front Laser Blockers – Optional (Purple Stripe) D Rear Laser Blocker – Optional (Green Stripe) E GPS Antenna (Yellow Shrink) F Display Module (Orange Shrink) G Control Module (Blue Shrink) H Concealed Alert Indicator (Gray Shrink) I Powered Speaker J Radio Mute K USB I I F G H J K B C C D E A I F Interior of Vehicle B E G A H 12 Volt
E GPS Antenna Yellow Shrink Interior Mounting Bracket 1 Determine the best location for the GPS antenna. The GPS Antenna requires a clear view of the sky. The magnetic base can be used on most vehicles to mount to the roof of the car or the trunk lid. For vehicles with non-magnetic surfaces such as aluminum or plastic, a window-mounted bracket is included for interior mounting. It can also be mounted to the dashboard or rear deck using double-sided tape.
F Display Module Orange Shrink 1 Determine the best location for the Display Module. If installed by a professional, the customer should be consulted. An optimal location is clearly visible from the driver’s position and does not take a driver’s eyes off the road for more than a moment. Display Bezel Mounting Display Bezel Mounting (Continued) 1 The supplied display bezel can be used to mount the Display permanently in the dash or console.
H Concealed Alert Indicator Gray Shrink I Powered Speaker Operation Test After all components are installed correctly: 1 Determine the best location for the Alert Indicator. If installed by a professional, the customer should be consulted. An optimal location is clearly visible from the driver’s position and does not take a driver’s eyes off the road for more than a moment. 1 Determine the best location for the Speaker.
