Specifications

Fitting to the sun visor

1. Remove the cover from the mounting bracket on top

of the unit by pushing in the rough part and at the

same time sliding it backwards. Keep the cover safely.

2. Slide the detector on to the base plate until it clicks

fast. See figure 5.

3. Clip the detector to the edge of the sun visor as close

as possible to the windscreen. See figure 6.

Mounting on the dashboard

You can also mount the unit on a flat section of the

dashboard using the hook and loop fastener or with the

four anti-slip feet supplied with the unit.

Replacing fuse

1. If the fuse has blown, you should remove the top of

the cigarette-lighter plug and then remove the old

fuse (see figure 7). Replace the fuse with a 1A fuse

(3AG). If you fit a fuse with too high a rating or

bridge the blown fuse, the detector or the electrical

system in your car may be damaged. Defects caused

in this way are not covered by the warranty.

Figure 5

Figure 7

Figure 6