User Manual

1
INSTALLATION FOR CC-100-S COMPETITOR CLUTCH
Assembled CC-100-S
A. CC-100-CS Set of 7 steels
B. CC-100-CP Set of 5 friction plates
C. CC-100-PP Pressure plate
D. CC-160H Clutch Hub
E. CC-100HH Hub housing
F. EHB-100 Hub bearing
G. CC-100HR Housing retainer with 4-5/16-18 x 3/4 buttonhead screws
H. CC-100HN Hub nut with adjustment screw and nut
I. CDCS-100 Set of 9 clutch springs
J. CDSB-100 Set of 9 shoulder bolts
K. CC-158 C-Clip
L. CC-244 C-Clip
Remove 4 bolts on back plate, remove the 9 shoulder bolts and springs from pressure plate.
Remove clutch plates and steels and install hub assembly into clutch basket.
Re-install housing retainer using the 4 buttonhead screws.
Install basket assembly onto transmission mainshaft.
Install hub nut with seal and tighten to Harley specs.
Re-install clutch plates and steels, install 2 steels first then alternate fibers and steels ending with a steel.
Install pressure plate with springs and shoulder bolts, screw shoulder bolts all the way in and tighten slightly be
sure to use thread locker.