Datasheet

PRODUCT SPECIFICATION
REVISION: ECR/ECN NUMBER: DOCUMENT NUMBER SHEET No.
1
EK2017-0***
PS-80397-001
5 of 11
DATE: CREATED / REVISED BY: CHECKED BY: APPROVED BY:
2017 / 05/ 22
Eric Bai
TEMPLATE FILENAME: PRODUCT_SPEC
REV 0.1,SHEET
SIZE
A4
20070830
10 Vibration
Waveform:Sine wave
Frequency:10-55-10 Hz in 1 minute
Amp:1.52mm
Direction: X.Y.Z.(3 directions)
Duration:2 hours per each direction
Discontinuities:<0.1µs. (EIA-364-28
Condition VII, Test letter D)
Appearance: no damage.
Discontinuity: 1 microsecond
Max
11
4-Axis Continuity
Test
The connector family shall be tested for
continuity under stress using the test
configurations shown in following figure.
Apply an 8N tensile force to the cable in a
direction of perpendicular to the axis of
insertion for 10 seconds at least.
Measure the continuity across each
contact and conform that each non-ground
contact shall not short to the shell during
the stresses.
Repeat the test for 90 degree, 180 degree
and 270 degree rotations.
Discontinuity1 μs MAX.
&
Non-ground contact not any
shorting to the shell
12 Wrenching Strength
First time: A moment of 0.75 Nm (for
example: 50 N at 15 mm). Fig.4.1
Second time: A new Plug is required for
each of the four test directions. A moment of
2.0 Nm is applied to the plug in the up and
down directions and 3.5 Nm is applied to the
plug in the right and left directions.Refer to
Fig.4.2
First time ：No Discontinuity
or shorts allowed.
Dielectric withstanding
Voltage ：No disruptive
discharge for 100VAC
Second time : 0.75Nm MIN.
Refer to Fig.4
13 Reseating
Manually unplug/plug the connector or
socket, perform 3 such cycles.
Appearance: No abnormality
Function : OK