Datasheet

PRODUCT SPECIFICATION
REVISION: ECR/ECN NUMBER: DOCUMENT NUMBER SHEET No.
1
EK2017-0***
PS-80397-001
3 of 11
DATE: CREATED / REVISED BY: CHECKED BY: APPROVED BY:
2017 / 05/ 22
Eric Bai
TEMPLATE FILENAME: PRODUCT_SPEC
REV 0.1,SHEET
SIZE
A4
20070830
1.0 SCOPE
This product specification defines the product performance and the test methods to ensure the
performance of the USB TYPE C , which is designed and manufactured by Bellwether Electronic corp.
Applicable material No：80397 series
Tests and inspection shall be performed in accordance with the requirements, tests and methods
contained herein. A re-qualification test shall be conducted immediately following all major process
changes.
2.0 APPLICABLE DOCUMENTS AND SPECIFICATIONS
EIA-364.
The following documents are part of this specification between the requirements of this
specified herewith. In the event of conflict between the requirements of this specification and the
product drawings, the product drawings shall take precedence. In the event of conflict between
the requirements of this specification and reference documents, this specification shall take
precedence.
3.0 REQUIREMENTS
3.1 DESIGN AND CONSTRUCTION
Product shall be of the design, construction and physical dimensions specified on the applicable product
drawing.
3.2 MATERIALS
Materials used in the construction of product shall be as specified on the applicable product drawing.
4.0 RATINGS
Voltage ：20V AC Per Contact
Current： A current of 5 A shall be applied collectively to VBUS pins (i.e., pins A4, A9,
B4, and B9) and 1.25 A shall be applied to the VCONN pin (i.e., B5 of the plug connector)
with the return path through the corresponding GND pins (i.e., pins A1, A12, B1, and B12). A
minimum current of 0.25 A shall also be applied individually to all the other contacts.
Operating temperature range：- 55 ℃ + 85℃
Storage temperature range: - 55℃ + 85℃
Humidity: 95% max. non condensing
5.0 PERFORMANCE AND TEST DESCRIPTION
The product is designed to meet the electrical, mechanical and environmental performance
requirements specified in Figure 1. Unless otherwise specified, all tests shall be performed at
ambient environmental conditions per EIA-364.
5.1 APPEARANCE REQUIREMENTS
ITEM
TEST DESCRIPTION
TEST CONDITION REQUIREMENT
1
Visual and
dimensional
inspections
Visual, dimensional and functional per
applicable quality inspection plan.
Per EIA 364-18
Meets requirements of
product drawing. No physical
damage.
5.2 ELECTRICAL REQUIREMENTS
ITEM
TEST
DESCRIPTION
TEST CONDITION
REQUIREMENT