Datasheet

PRODUCT SPECIFICATION
REVISI ECR/ECN DOCUMENT NUMBER SHEET
A
EK2015-0***
PS-80239-001
4 of 8
DATE: CREATED / REVISED CHECKED BY: APPROVED BY:
2015/08/03
Eric Bai Jerry Wang Larry Chen
3.7.2 Packaging carton with products should be subject to falling test.
3.7.3 Other requirements see Bellwether’s packaging specification .
3.8 Test Description
The product is designed to meet the requirements specified in section 3.9. Unless otherwise
specified, all tests and measurements are to be performed at the following conditions:
Temperature: 15℃ to 35℃.
Relative Humidity: 25% to 85%.
Atmospheric pressure : 86kPa to 106 kPa.
3.9. Test Requirements and Methods
3.9.1 Appearance
Items Test Methods Requirements
Appearance
Comply with method EIA 364-18. Visual inspection
in compliance with applicable specification and
document are performed. The test samples shall be
free from defects such as damage, creep,
deformation, blister and burrs that are detrimental to
the function and appearance of test samples.
Connector & contact shall have no
evidence of physical defects or
otherwise unfit for testing.
Electrical Performance :
3.9.2 Low Level
Contact
Resistance
Comply with method EIA 364-23.
Open circuit voltage is 20mV maximum and test
current is 100mA.
Measurement to use Kelvin 4-wire method.
Initial:40 mΩ maximum initial for
the Power (VBUS) and
Ground (GND) contacts and
all other contacts .
After test:Change from initial
value:10 mΩ maximum .
3.9.3 Dielectric
Withstanding
Voltage
Comply with method EIA 364-20.
The dielectric must withstand 100 VAC (RMS)
for one minute at sea level between adjacent
contacts of unmated and mated connectors.
No Breakdown.
3.9.4 Insulation
Resistance
Comply with method EIA 364-21.
Mated connector with a voltage of 100V DC for
two minutes maximum, or until stabilized between
adjacent terminals.
100 MΩ minimum.
3.9.5 Contact
Current Rating
Comply with method EIA 364-70 Method 2.
A current of 5.0 A shall be applied collectively to
Vbus pin(i.e., pins A4,A9,B4.B9) and 1.25 A
applied to the VCONN pin(i.e.,B5 of the plug
connector) with the return path through the
corresponding GND pin(i.e., pin A1,A12,B1, and
B12). Additionally, a minimum current of 0.25 A
shall be applied individually to all the other
contacts.
When the current is applied to
the contacts, the temperature
rise shall not exceed 30℃ at
any point on the USB Type C
mated plug and Connector
under test, when measured at
an ambient temperature of 25℃
Mechanical Performance :
3.9.6 Insertion
Force
Comply with method EIA 364-13.
The mating force is the peak force measured
while the plug and Connector sample are mated
normally. Mating speed: 12.5 mm per minute
maximum.
The initial connector insetion
force shall be within the range
from 5 N to 20N .
3.9.7 Extraction
Force
Comply with method EIA 364-13.
The unmating force is the peak force
measured while the plug and Connector sample
separated from the mated position. Un-mating
speed: 12.5 mm per minute maximum.
The connector extraction force
shall be within the range of 8 N
to 20 N up to 1,000 mating
cycles and within the range of 6
N to 20 N after the specified
insertion/extraction or durability
cycles