Datasheet

PRODUCT SPECIFICATION
REVISION:
ECR/ECN NUMBER:
DOCUMENT NUMBER
SHEET No.
1
EK2016-0203
PS-80210-001
5 of 8
DATE:
CREATED / REVISED BY:
CHECKED BY:
APPROVED BY:
2016 / 07/ 03
Kaysen Chen
Jerry Wang
Jerry Wang
TEMPLATE FILENAME: PRODUCT_SPEC REV 0.1,SHEET SIZE A4 20070830
9
Cable Pull-out
Apply a 40N axial load to cable assembly
for a minimum of 1 minute while clamping
one end of the cable plug.
Per EIA 364-38, Method A
No physical damage
10
4-Axis Continuity
Test
The connector family shall be tested for
continuity under stress using the test
configurations shown in following figure.
Apply an 8N tensile force to the cable in a
direction of perpendicular to the axis of
insertion for 10 seconds at least.
Measure the continuity across each
contact and conform that each non-ground
contact shall not short to the shell during
the stresses.
Repeat the test for 90 degree, 180 degree
and 270 degree rotations.
Discontinuity1 μs MAX.
&
Non-ground contact not any
shorting to the shell
11
Wrenching Strength
Apply a perpendicular force to a plug when
inserted at a distance of 15mm from the
edge of the receptacle.
The force shall be applied in all four
directions （i.e., left, right, up, and
down）.
0-50N No plug or receptacle
damaged
50-75N The plug may be
damaged, No damage in
receptacle
12
Vibration
Amplitude: 1.52mm p-p
Sweep time: 50-2000-50 Hz in 20minute.
Duration: 12 times in each X, Y, Z. Axes.
Electrical load: DC 100 mA current shall be
flowed during the test
Per EIA-364-28 Condition III
Discontinuity1 μs MAX.
&
No physical damage
&
10 milliohms MAX.
(change from initial)