Operation Manual

Advanced testing
Testing the telephone transmitter is easy. First, make sure that the telephone
transmitter is installed properly. For instructions, read the section Installation.
Using the test button
Press both test buttons simultaneously.
1 The transmitter’s LED lights up to show that a radio signal is being transmitted.
2 The Visit receiver’s telephone symbol lights up to show that the signal was received.
If you have customized the signal, it will react accordingly. See tables on page 67-70.
Using a telephone or a connected accessory
Activate the telephone transmitter using the telephone or any of the accessories.
1 The transmitter’s LED lights up to show that a radio signal is being transmitted
2 The Visit receiver’s telephone symbol lights up to show that the signal was received.
If you have customized the signal, it will react accordingly. See tables on page 67-70.
If it doesn’t work as described above, read the section Trouble shooting.
Transmitter rce Receiver
Source LED LED Sound Vibration Flash
Landline phone Green, top Yellow light 1 x ring, Lo Fast Yes
Smartphone Green, top Yellow blink 2 x ring ring, Hi Fast Yes
Contact mat
Magnetic switch
Doorbell etc.
Green,
bottom
Green light 1 x ding dong, Lo Slow Yes
Default indication and signal
Transmitter indication
When the transmitter is activated, the LED lights up in green. This means that
the batteries are in good condition. Change batteries if the LEDs blink in orange.
Receiver signal
When a receiver is activated, it signals with sound, ashes or vibrations. The
default signal pattern is as follows:
63 64