User manual

60 61

SI-CN

TR-CN

APP

Symbols and indicators

The following symbols are used in the user manual and can be explained as

follows:

The warning triangle indicates information which must be followed in

order to guarantee operation and also in some cases to ensure personal

safety.

The light bulb (tip, note) indicates information which can be useful to

help you get the most out of the product.

I A permanently lit LED is indicated by solid indi-

cator.

II A blinking LED is indicated by a sunlike solid

indicator.

III Indicators that are switched o are indicated by

an empty circle.

IV If a button must be held down for more than a

certain time, this is indicated by a grey button

and a stop watch symbol with a gure which

corresponds to the number of seconds that the

button must be held down for.

V Button presses are marked in grey on the speci-

ed button.

Charging

Both the Transmitter and Receiver Units are supplied with built-in rechargeable

batteries. The batteries in both the Transmitter and Receiver Units must be

charged before using the products for the rst time.

Bellman Audio Domino Classic contains Lithium-Ion batteries and a universal

charger with plugs for the EU, United Kingdom, USA and Australia to suit the

majority of wall sockets used around the world.

Warning: The product may only be charged with the charger supplied or

using accessories from Bellman & Symfon.

Connect the charger as illustrated in the fold-out section of the manual.

Select the mains plug for the appropriate region and check that it is locked

properly before it is connected to the wall socket. When the charging connec-

tors are connected to the charger, the Transmitter Unit and the Receiver Unit,

the Battery Status LEDs (3 and 17) change from green to orange to indicate that

charging is taking place. When charging is nished, after about 2.5 hours, the

LEDs turn green again. You can charge one unit at a time or two at the same

time.

III

5 s