User manual

316 317

APP

Testing

It is easy to test the Bellman Audio Domino Classic Personal Hearing System. If

the Bellman Audio Domino Classic does not operate as described below, you

can carry out further troubleshooting as instructed under Troubleshooting.

How to test

The testing of Bellman Audio Domino Classic has been divided into three parts.

One part for the Receiver Unit for which only the Receiver Unit is required, one

part for the Transmitter Unit for which both units are required and nally one

for charging the two units.

Receiver Unit

• Switch on the unit and make sure that the Battery Status LED (3) lights up green.

• Connect the headphones to the Headphone Socket (13) and scrape carefully

on the round microphone (1) with your nger and check that there is a scraping

sound in the headphones.

• Press the buttons (9, 10, 11, 12) and check that the Volume and Tone Indicator

changes.

Transmitter Unit

• Switch on the unit and make sure that the Battery Status LED (17) lights up green.

Proceed as follows to pair up the units:

• Start both the units with the

On/O buttons i (6, 18).

• Go into the Settings Menu.

• Hold down the

CONNECT

button (19) on the Trans-

mitter Unit.

• Hold down both the M

button (5) and the R but-

ton (7) on the Receiver Unit.

A ”running light” on the Receiver Unit’s Volume and Tone LED Indicator (8)

moving towards the centre indicates that the link has been established.

Please note! If you pair up a Transmitter Unit and a Receiver Unit in the

Settings Menu, this replaces the pairing carried out in the factory. This can

be useful when changing a Transmitter Unit under guarantee or if you want

to pair up several Receiver Units to a Transmitter Unit (e.g. in a conference

room).

5 s