User manual

314 315
APP
Appendix
Settings
Bellman Audio Domino Classic has some settings that you cannot access in user
mode. Go into the Settings Menu to change settings that you do not normally
need to change.
Settings Menu
Start the Receiver Unit with the On/O button i (6).
Hold down the On/O button i (6) and press the
Volume Button -(10) within 1 second until the RF LED
(4) starts to blink. When the RF LED (4) starts to blink,
you can release both the buttons.
Press the R button (7) within 2 seconds of the mo-
ment the RF LED (4) starts to blink and hold down the
button until the RF LED (4) goes out. Release the R
button (7) immediately when the RF LED (4) has gone
out.
You are now in Version Information mode.
Version information
The product version information is presented here
via a pattern of lit and blinking LEDs. This internal
information is only intended as an aid for servicing
and support.
Pairing of units
The Transmitter and Receiver Units in the Bellman Audio Domino system must
have the radio link established in order for radio communication to operate. To
make it easier to get started, a Receiver Unit and a Transmitter Unit which are
paired together are always supplied so that they will work together.
Where you want to pair a Receiver Unit with a Transmitter Unit which is dier-
ent from the Receiver Unit it was originally supplied with, you can do this in the
Settings Menu.