User's Manual
Introduction
Settings
No adjustments are required for normal use. The relevant descriptions are provided below,
if you wish to change a setting for some reason.
Changing the radio key
In order to use several Visit systems close to one another without interference, different
radio keys can be set on the dierent systems. All Visit units from the factory are set to the
same radio key, channel 0. This means that all radio key switches on the transmitters are set
to the OFF position.
Here is how you change the radio key:
Open the transmitter cover and move any radio key switch to the up=on position to
change the radio key. See Changing the radio key for the relevant transmitter.
Press and hold the mute/test button on the top of the receiver until the green and yel-
low
Visit LED’s blink alternately. Release the button.
Press the test button/s on the transmitter within 30 seconds to send the new radio key.
All Visit LEDs on the receiver blink 4 times to show that the radio key has
been changed. It then returns to normal mode.
Please note: All Visit units must be set to the same radio key in order to operate as a group.
Signal pattern
A signal pattern decides how the receiver in the Visit system indicates during the activa-
tion. Changing the transmitter signal switch changes the signal pattern which the receivers
display when the transmitter is activated.
See the transmitter user manual for further information.
10
BE1444_005MAN002-433-Visit-Flashreceiver.indb 12 2017-09-06 09:33:54