User's Manual

+
Pairing with easyTek
Press and simultaneously on easyTek until easyTeks blue LED
starts to ash. The LED will then stay lit for 5 seconds during the pairing
procedure. When pairing is completed the LED will turn o.
If no steady light appears, ensure that easyTek is within range from the
Smart hub and try pairing the units again, see the easyTek user guide.
Setting up the Smart hub
1 Pull the battery tab to start the unit. Remove the protective lm from
the Velcro® and mount the Smart hub on the wall.
2 Plug the power supply into the mains outlet.
3 Press and hold the top button until the top led starts to blink in blue.
1
2
Steady
Pairing
O
Done
Flashing
Ready
5 6
3
+