20130917 issue 1 啊哈 BBQ Range Hood Installation and User manual Content Safety instructions---------------------------------- 2 Product description--------------------------------- 4 Installation & start using--------------------------- 6 Maintenance and cleaning------------------------9 Warranty-----------------------------------------------10 For warranty service call 1300 373 199(Australia) or 0508 123108(New Zealand) to connect you to the nearest authorised service centre 1 BBQR123X BBQR123X-F
Safety instructions This manual explains the proper installation and use of your range hood, please read it carefully before using even if you are familiar with the product. The manual should be kept in a safe place for future reference.
Safety instructions Never to do: Always to do: z z z It is prohibited to fit the range hood over a solid fuel stove applicable regulations concerning discharge This appliance must not be connected to a chimney of exhaust air are fulfilled. or vent flue which is in use. z z z This appliance should be installed and This appliance is not to be vented into the roof maintained by a suitably qualified and cavity, must exit into open air.
Product description Accessories Description Component list: Picture QTY User Manual 1 Upper chimney retaining bracket 1 Lower chimney retaining bracket 1 Hood mount bracket 1 Dry wall anchors plugs 12 Screw (ST4x8mm) 4 Screw (ST4x30mm) 12 Technical data: 1. Chimney cover 2. Upper chimney retaining bracket 3. Upper decorative chimney (Inner) 4. Lower chimney retaining bracket Power supply: 220 – 240v, 50Hz 5. Lower decorative chimney (outer) Motor: 2 x 320W 6.
Installation and start using your range hood Dimensions: Installation Procedures: Warning: Check that the installation complies with the standards of local building, gas and electrical authorities. Before connecting to the mains supply ensure the mains voltage corresponds to the voltage on the appliance rating plate inside the range hood. When installing the range hood, make sure you adhere to the minimum and maximum distances from the range hood base to the cooktop hob surface.
1. Using a spirit level, mark a vertical line on the wall (Central to the cook top installed below) to indicate the centre location of the hood and a horizontal line where the hood base will be positioned. Drill holes as per below drawing and insert dry wall anchor plugs into holes. NOTE: The distance from the horizontal line to an electrical cooktop underneath must be minimum of 600mm & 650mm to the gas cook top and a maximum height of 750mm (refer to table below).
2. Fasten Hood mount bracket by 4pcs ST4x30mm screws. 3. Hang on the main body of range hood. 4. Fit the outlet and flexible exhaust duct onto outlet 5. Slide out Upper Decorative Chimney to desired height.
6. Fasten Upper chimney retaining bracket by 4 pcs ST4x30mm screws, then fasten 2 pcs ST4x8mm screws at side to fix Upper Decorative Chimney. 7. Remove all blue protective film on chimney and cooker hood, the installation is now finished. Start using your range hood O – off button, used for turning off the fans.
Maintenance and cleaning Caution: The baffle filters can be cleaned either by hand or in • Before maintenance or cleaning is carried out, the the dishwasher. After cleaning ensure that the filters range hood should be disconnected from the main are completely dry before refitting. power supply. Ensure that the range hood is switched - By hand: Soak in warm water and a neutral off at the wall socket and the plug removed. washing up liquid.
WARRANTY 1.1 In this warranty: 1.1.1 Australian Consumer Law means the law as set out in Schedule 2 of the Competition and Consumer Act 2010; 1.1.2 Company means GSM Sales Pty Ltd ABN 53 007 682 475 of 142-144 Fullarton Road, Rose Park SA 5067. Telephone 08 8122 2390. Email admin@gsmsales.com.au; 1.1.3 Consumer means a “consumer” as that term is defined in Section 3 of the Australian Consumer Law as the original purchaser of a Bellini product; 1.1.
1.8 You must provide proof of your purchase of the Bellini product and the date of purchase in order to obtain the benefit of this warranty. 1.9 If you live outside the service area of the Company or one of its service agents, this warranty does not cover the cost of transport of the Bellini product for service nor the service agent’s traveling costs to and from your home. 1.
