Technical data

INSTALLATION
13.302
Connect gas hob to gas supply
The inlet is at the rear right hand side of
the hob.
The hob may be connected to the gas
supplyeitherbyrigidpipeworkorexible
connection.
Flexible connections
Usea900mm-1125mmlengthofex-
ible connector. Ensure that the hose is
installed hanging freely downwards, is not
trapped, is not subjected to undue forces
and is not supported at the bottom by a
horizontal surface.
Natural Gas - Flexible connections should
comply with BS669, latest edition.
LPGas-Forexibleconnectionsusea
bayonet type hose, suitable for use on LP
gas up to 50 mbar pressure rise and 70°C
temperaturerise.Theexiblehoseshould
be coloured black with a red stripe, band
or label. If in doubt, contact your supplier.
Theinstallationmustensurethattheex-
ible tube cannot come into contact with
movable parts of the housing unit (e.g. a
drawer) and does not pass through any
space susceptible to becoming congested.
Make sure the appliance is gas sound
& all components are operating cor-
rectly.
Connect to the electricity supply
Unless this appliance is supplied with a
ttedplug,itmustbeconnectedbya
competentperson,usingxedwiringvia
a double pole switched fused spur outlet,
with a contact separation of 3mm at all
poles.
Connect the mains lead wires to the termi-
nals:
The blue wire must be connected to the
terminal marked N (Neutral) LOAD or
coloured black. The brown wire must be
connected to the terminal marked L (Live)
LOAD or coloured red.
The green/yellow coloured wire must
be connected to the terminal marked E
(Earth) or coloured green.
Warning: this appliance must be
earthed.
The fused spur must be accessible after
installation.
If the supply cord is damaged, obtain
a special cord from the Customer Care
Helpline,whichmustbettedbyaquali-
edperson.