Technical data

INSTALLATION
13.302
Important Information
It is important when installing front con-
trol gas hobs, that the work top cut out is
the same as is quoted in this installation
manual. If the cut out is too large, then
batonsmustbettedtothefront,rear
and sides - to correct the discrepancy and
ensurethecorrectt.Pleaseensurethat
ifbatonsarettedtheyarelevelwiththe
top surface of the work top. Please ensure
that the seal for the hob has full contact
with the work top surface.
There are two ways to install the clamps,
depending on the thickness of the work
top. Please measure the thickness of
your work top and ensure that the cor-
rect method is used. Both methods are
detailed in the installation manual.
Failure to follow these instructions can
lead to excessive force being applied to
the base tray, which results in the clear-
ance between the control knob and the
hob top pressing being reduced. This can
effect the operation of the gas control,
and the ignition.
Base Tray
GDHA specified dimensions with batons
Existing dimension without batons
Fit the hob into the cutout & secure
to work top
Place the hob into the cutout and se-
cure in place using the four brackets
and screws
provided.
The brackets
should be ori-
entated to suit
the work top
thickness as
shown, then in-
serted into the
four slots (two
on the front
edge and two
on the rear)
and screwed into the underside of the
work top using the wood screws provided.
The screws should be tightened just suf-
cientlytosecurethehobandpullthetop
pressingushwiththeworktop.
If the base of the hob is accessible after
installationthenapartitionmustbetted
20mm below the base to prevent access.
Installation advice - cabinets
Dealing with sides, cross-rails and
back-panels in cabinets
Depending on the cabinets, the work
top thickness and the hob positioning, it
is possible for the hob base, the clamp
brackets and/or the gas connection to
interfere with parts of the cabinet. These