Technical data

INSTALLATION
13.302
Installation
This appliance must be installed in accor-
dance with the regulations in force, and
only in a well ventilated space. Read the
instructions before using or installing this
appliance.
This appliance is factory set for use with
natural gas only.
Regulations & Standards
Prior to installation, ensure that the local
distribution condition (nature of the gas
and gas pressure) and adjustment of the
appliance are compatible.
The adjustment conditions for this appli-
ance are stated on the data badge.
This appliance is not connected to a com-
bustion products evacuation device.
It shall be installed and connected in ac-
cordance with current installation regula-
tions. Particular attention shall be given
to the relevant requirements regarding
ventilation.
The appliance must be installed, convert-
ed to LPG (where necessary) and serviced
by a competent person to ensure that the
installation is in accordance with “The Gas
Safety (Installation & Use) Regulations”, &
the “The Gas Safety (Installation & Use)
(Amendment) Regulations ”.
Failure to comply with these Regula-
tions is a criminal offence.
Where regulations or standards have been
revised since this handbook was printed,
always use the latest edition.
All gas installation, servicing and repair
work must be in accordance with local
standards and regulations
In the UK the regulations and stan-
dards are as follows (inclusive of
successive issues:
1. Gas Safety Regulations (Installation and
Use).
2. Building Regulations - Issued by the
Department of the Environment.
3. Building Standards (Scotland) (Consoli-
dated) - Issued by the Scottish Develop-
ment Department.
4. The current I.E.E. Wiring Regulations.
5. Electricity at Work Regulations.
6. BS6172 Installation of Domestic Gas
Cooking Appliances. Also, for LP Gas
refer to BS5482 Part 1, Part 2 or Part 3 as
relevant.
7. Installation & Servicing Instructions for
this appliance.
For installation in countries other than the
UK, the appliance must be connected in
accordance with all local gas and electrical
regulations.
In the Republic of Ireland, installers should
refer to IS813 Domestic Gas Appliances.