ILF800 Fully Integrated Larder INSTALLATION AND USER INSTRUCTIONS You must read these instructions prior to using the appliance and retain them for future reference.
Contents Introduction & safety warnings...........................................................................2 Electrical requirements ......................................................................................3 Transportation instructions.................................................................................4 Installation instructions.......................................................................................5 Repositioning the door .....................................
Congratulations on your choice of a Belling quality Appliance which has been designed to give you service for many years. WARNING ! IMPORTANT ! DO NOT connect the appliance to the electricity supply until all packing and transit protectors have been removed. • Leave to stand for at least 4 hours before switching on to allow compressor oil to settle if transported horizontally.
ELECTRICAL REQUIREMENTS Before you insert the plug into the wall socket make sure that the voltage and the frequency shown in the rating plate inside the appliance corresponds to your electricity supply. Rating label is on the left hand side of fridge liner. We recommend that this appliance is connected to the mains supply via a suitable switched and fused socket in a readily accessible position.
TRANSPORTATION INSTRUCTIONS 1. The appliance should be transported only in a vertical upright position. The packing as supplied must be intact during transportation. 2. If during the course of transport the appliance has to be transported horizontally, it must only be laid on its left hand side when standing in the front of the appliance. After bringing it to upright position,it must not be operated for at least 4 hours to allow the system to settle. 3.
IMPORTANT INSTALLATION INSTRUCTIONS 1. To avoid a hazard due to instability of the appliance, it must be fixed in accordance with the instructions. 2. Do not operate this appliance unless installed to furniture. 3. The appliance should be located on a smooth surface. The four front and back feet can be adjusted as required. To ensure that, your appliance is standing upright adjust the four front and back feet by turning clockwise or anti-clockwise, until the product is in firm contact with the floor.
REPOSITIONING THE DOOR Follow the step by step instructions and the diagram below. Numbers in brackets refer to diagrams.
1. Switch off at the socket outlet and pull out the mains plug. 2. Remove all food, loose items and fittings from inside the appliance and door shelves. 3. Unscrew the bolts and remove the upper and bottom hinges from the cabinet and door. (1) (2) 4. Remove stoppers. (3) (4) 5. Fit the stoppers on the opposite side. (5) (6) 6. Reposition the upper hinge on the opposite side as bottom hinge (7) 7. Reposition the bottom hinge on the opposite side as upper hinge.
SUGGESTED ARRANGEMENT OF FOOD IN THE LARDER FRIDGE 6 5 4 1 1 1 2 3 7 Arrangement Examples (See diagram). 1. Baked, chilled cooked food, dairy products. 2. Meat, sausages, cold cuts, cans. 3. Fruit, vegetables, salads. 4. Tubes, small bottles and cans. 5. Egg tray. 6. Butter, cheese, dairy products. 7. Beverages, large bottles.
The following guidelines and recommendations are suggested to obtain the best results and storage hygiene. 1. Appliance is for the short term storage of fresh food and drinks. 2. Cooked dishes must be stored in airtight covered containers and are best placed on either of the removable shelves. 3. Fresh wrapped produce can be placed on the shelf. Fresh fruit and vegetables should be cleaned and stored in the crisper bins. 4. Bottles can be placed in the door section. 5.
STARTING Final Check Before you start using the refrigerator check that: 1. The feet have been adjusted for perfect levelling. 2. The interior is dry and air can circulate freely. 3. Clean the interior as recommended under "CLEANING AND CARE." 4. Insert the plug into the wall socket and switch on the electricity supply. When the door is open the interior light will come on. 5. You will hear a noise as the compressor starts up.
CLEANING AND CARE ** We recommend that you switch off the larder refrigerator at the socket outlet and pull out the mains plug before cleaning. ** Never use any sharp instruments or abrasive substances, soap, household cleaner, detergent and wax polish for cleaning. ** Use luke warm water to clean the cabinet of the refrigerator and wipe it dry. ** Use a damp cloth wrung out in a solution of one teaspoon of bicarbonate of soda to one pint of water to clean the interior and wipe it dry.
REPLACING THE INTERIOR LIGHT BULB (See diagram) Should the light fail to work switch off at the socket outlet and pull out the mains plug. Follow the instructions below to check if the light bulb has worked itself loose. If the light still fails to work obtain a replacement E14 screw cap type 15 Watt (Max) bulb from your local electrical store and then fit it as follows: 1. Switch off at the socket outlet and pull out the mains plug. You may find it useful to remove shelves for easy access. 2.
DO'S AND DON'TS Do- Clean your larder refrigerator regularly. Do- Keep raw meat and poultry below cooked food and dairy products. Do- Keep food for as short a time as possible and adhere to 'Best Before' and "Use By" dates. Do- Take off any unusable leaves on vegetables and wipe off any soil. Do- Leave lettuce, cabbage, parsley and cauliflower on the stem. Do- Wrap cheese firstly in greaseproof paper and then in a polythene bag excluding as much air as possible.
INSTALLATION INSTRUCTIONS - DETAILED STEP BY STEP NOTE 1) Height of the product can be adjusted by the help of adjustable feet (front and back) to fit the furniture niche height (B). 2) Do not operate this appliance until it has been installed in the furniture.
15
16
17
18
19
GUARANTEE DETAILS Your new Belling product is guaranteed against the cost of breakdown repairs for twelve months from the date of the original purchase. What is covered? • Repairs necessary as a result of faulty materials, defective components or manufacturing defect. • The cost of functional replacement parts, but excluding consumable items. • The labour costs of a Belling approved repairer to carry out the repair. What is not covered? • Transit, delivery or accidental damage or misuse and abuse.
problem solving section Recycling This product bears the selective sorting symbol for waste electrical and electronic equipment (WEEE). This means that this product must be handled pursuant to European Directive 2002/96/EC in order to be recycled or dismantled to minimize its impact on the environment. For further information, please contact your local or regional authorities.
Technical data PERFORMANCE Fully Integrated Larder ILF 800 Energy efficiency class A+ Energy consumption - Kwh/year 118 Net storage - vol fresh food ltrs (cu.ft.) 128 lt. (4.5) Net storage - vol frozen food ltrs (cu.ft.) ----- Total net vol - ltrs (cu.ft.) 128 lt. (4.
WIRING DIAGRAM 23
BELLING CUSTOMER CARE In case of difficulty within the UK, please call Belling Customer Care Centre Helpline on 0844 815 3746 When you dial this number you will hear a recorded message and be given a number of options. This indicates that your call has been accepted and is being held in a queue. Calls are answered in strict rotation as our Customer Care Representatives become available.
