Technical data

Installation Instructions
Fitting into worktop
• Cut a hole in the work surface to the
required size. See table for relevant
dimensions.
A clearance of at least 50mm should be
maintained between the cutout and any
rear or side wall.
• The worktop must be of heat-resistant
material or covered with heat-resistant
material.
• Protecting the cut-out;
The types of chipboard used for work
surfaces swell relatively quickly in con-
tact with humidity.
Apply a special varnish or adhesive to the
cut edge to protect it from steam or con-
densation which may form under the
work surface under the hob.
This hob can be installed conventionally
(glass above the work top) or recessed into
the work top for a flush fit.
Conventional Installation
Apply the self adhesive seal to the underside
edges of the hob glass. For best results, the
seal should be adhered along each side in
turn, as close to the edge as possible, and
trimmed at each corner, taking care to
ensure a neat join.
Place the hob in the aperture, checking the
hob glass is covering the work top along all
four sides. Set the front edge of the appli-
ance parallel with the front of the work top.
Locate and attach the securing clamps to
the front and rear underside of the hob,
using the 2-off pozidrive self-tapping screws
provided. Tighten the screws so that the
hob is pulled down firmly against the work-
top, thus ensuring a good seal.
Cutout required
WIDTH
550mm
DEPTH
480mm
Clearance required
SIDE WALL
53mm
REAR WALL
53mm
Important: Clamps may
be reversed to fit either 30mm or
40mm deep work top.
i
29
Screw
Clamp
Seal
Worktop