Technical data

INSTALLATION INSTRUCTIONS - DUAL FUEL
Fitting the plinth (if applicable)
• Ensure the appliance is raised to a
height of 915mm or above using
adjusting feet (A) before beginning.
• Open the appliance doors andloosen
screw (C), do not remove the screw
entirely. If your appliance has a stor-
age drawer at the bottom, you access
thescrews through holes located at
the base of the drawer after lifting
the mat.
• Fit plinth (B) and secure using screw
(C).
Fitting the splashback (if applicable)
• LooselytscrewAandnutBinto
hole 1 at both ends of the rear sur-
face of the appliance.
• LocatettedscrewAthroughthe
slots in both of themetal splashback
plates.
• Tighten screw A and nut B.
• Now locate and tighten screw C and
nut D through hole (2) at both ends
of the rear surface of the appliance.
Make sure that the splashback is
securely attached, but avoid over
tightening.
Fitting the towel rail (if applicable)
• On the towel rail there are two hole,
top (A) and bottom (B), these holes
have corresponding holes on the
fascia at each end.
• The screw for the top hole (A), must
be screwed into the supplied adaptor,
where as the remaining screw just
goes through the bottom hole (B).
Both screws are M6 screws. Using
the allen key provided, tighten the
screws making sure that the towel
railisushtothefascia,butnot
over tightened.