Users Guide & Installation Handbook Belling 77cm Hob Touch UK Part No 083316700 Date 15/07/2013
CONTENTS & INTRODUCTION CONTENTS • SAFETY • USING THE PRODUCT • CLEANING • INSTALLATION INSTRUCTIONS • TECHNICAL DATA • CUSTOMER CARE INTRODUCTION Thank you for buying this Britishbuilt appliance from us. This guide book is designed to help you through each step of owning your new appliance, from installation to use. Please read it carefully before you start using your product, as we have endeavored to answer as many questions as possible, and provide you with as much support as we can.
SAFETY BEFORE USING THE PRODUCT Make sure that you have removed all packaging and wrapping. Some of the items inside this appliance may have additional wrapping. GENERAL WARNING! - The appliance and its accessible parts become hot during use. Care should be taken to avoid touching heating elements. Children less than 8 years of age shall be kept away unless continously supervised.
SAFETY during use, as this will seriously affect the safety and performance, particularly in relation to surface temperatures becoming hot and gas operated parts not working efficiently. The cooling fan (if fitted) is designed to run on after the control knob has been switched off. WARNING! Do not spray aerosols in the vicinity of this appliance while it is in operation. WARNING! - Do not store or use flammable liquids or items in the vicinity of this appliance. WARNING! Do not modify this appliance.
SAFETY electrical switch. Contact your local gas supplier immediately. ELECTRIC INDUCTION HOB WARNING:Unattended cooking on a hob can be dangerous and may result in fire. NEVER try to extinguish a fire with water, but switch off the appliance and then cover flame e.g. with a lid or a damp cloth. Danger of fire: do not store items on the cooking surface.
SAFETY fail-safe. The pacemaker must be designed in compliance with the appropriate regulations. Caution: This appliance is for cooking purposes only. It must not be used for other purposes, for example room heating. Prolonged intensive use of the appliance may call for additional ventilation, for example opening of a window, or more effective ventilation, for example increasing the level of mechanical ventilation where present.
SAFETY the hob when you’re not around - take them off the cook zone if you have to leave the kitchen even if you think it will only be for a moment, while you answer the door or phone. If you use a griddle plate ensure it is completely cool before attempting to lift it from the hob as residual heat may cause burns, Always use oven gloves to protect your hands. The appliance has a glass hob top, make sure you do not drag pans across the ceramic surface as this will lead to scratches and damage.
SAFETY This hob is not intended to be opertated by means of a external timer or seperate remote control system. kitchen: • Fire Safety Advice Pull the plug out, or switch off the power at the fuse box - this may be enough to stop the fire immediately • Smother the fire with a fire blanket, or use a dry powder or carbon dioxide extinguisher • Never use water on an electrical or cooking oil fire.
USING THE HOB - ELECTRIC (CERAMIC) 7 3 6 9 10 1 2 DUAL ZONE KEY KEY 2 KEY 3 KEY 1 8 KEY 4 5 4 fig 1 To select a setting on the selector; either Touch at one point to “jump” to a specific setting or slide your finger along the selector 1 KEYLOCK to respond to your touch. 2 ON/OFF KEY 3 COOK ZONE KEYS (1 - 4) Always ensure the touch control area is clean, dry and free from any objects (e.g.
USING THE HOB - ELECTRIC (CERAMIC) When power is first switched on the hob will always start up with the Key Lock activated. Key Lock A Red Led indicates when the key lock is active, to deactivate/activate, touch the Key Lock key for 1 second. The key lock is deactivated when the Red LED switches off. If any of the cook zones are ON, the key lock function locks all the keys except the ON/OFF key. 6, To adjust the power setting follow steps 3-5 above. 7, Repeat the above as necessary for the other zones.
USING THE HOB - ELECTRIC (CERAMIC) To operate the dual cook zone • • • Select the appropriate cook zone and set the power level as per the single zone Whilst the heater display is still flashing press the central dual zone key, a red LED will illuminate next to the cook zone to indicate it has been activated. The power level of the cook zone will stop flashing and the power level is set. • • • • • • To de-select the dual cook zone • Touch the cook zone Key, the power level display will start flashing.
USING THE HOB - ELECTRIC (CERAMIC) Timer (All Cook Zones) All 5 cooking zones can be operated under the timer independently and at the same time for up to 99 minutes. When the set time expires the timer will beep and the cook zone will switch off automatically. To Set The Timer To A Cook Zone 1, Set the desired power level to the cook zone.
ERROR CODES Appliance errors Event that generates the error Description (Visualization Priority Order) Microcontroller fault Microcontroller Internal Error Heater Display Effect in the (fore 0.5 sec./ back 0.5 sec) appliance ‘F0’ App. off ------- Normal status recovery On/Off key emitter fault Security Key Error ‘FA’ App. off When the fault disappears On/Off key receiver fault Security Key Error ‘FC’ App. off When the fault disappears Touch NTSC Error ‘FE’ App.
CLEANING ELECTRIC HOB follow the circular grooves and avoid damaging the red spots. Make sure that you allow the hotplate to dry before use by switching on the elements at a low heat. Ceramic glass hobs • • • It is recommended that you clean and wash the hob surface before using for the first time. Apply a thin coat of ceramic hob cleaner to the hob to help maintain and protect it. The ceramic hob top can be cleaned using a clean, damp cloth or kitchen paper.
INSTALLATION General information Installation should only be carried out by a qualified installer or engineer. between hob base and appliance must be maintained. Installation above an oven Please keep to the following points most carefully; Refer to the manufacturer’s instructions for clearances above the oven. Although every care has been taken to ensure this appliance has no burrs, or sharp edges, we recommend that you wear protective gloves when installing and moving this appliance.
INSTALLATION Clearances and dimension – requirements There must be a minimum clearance of 50mm between the rear edge of the hob and the rear wall. This clearance must be maintained up to 650mm above the worktop. No shelf or overhang of combustible material should be closer than 650mm above the hob. When installing an extractor hood above the hob, refer to their Manufacturer’s instructions.
INSTALLATION Fitting into worktop Recessed Method Cut a hole in the work surface to the required size. The worktop must be of heat-resistant material or covered with heat-resistant material. Recess the work top to the appropriate depth (Approx 5mm) and shape to fit the hob (add 1mm to overall glass size). Refer to the installation bracket advice to determine your installation type. Insert the hob into the recess, ensuring that the foam seal is sitting correctly.
INSTALLATION Installation Bracket Advice Installation pack 2 Secure the hob to the worktop by means of the brackets provided, taking the thickness of the worktop into account. 4 x Cranked installation bracket 4 x Spire clips (70/77/90cm appliances only) 4 x No8 Screws UNDERSIDE OF HOB Depending on your appliance the cranked bracket may or may not require the spire clips detailed in pack 1.
INSTALLATION CONNECT TO THE ELECTRICITY SUPPLY WARNING: This appliance must be earthed. Only connect to the electrical mains terminal with the power switched off. The electrical mains terminal is live. Follow the terminal block connection schematic • Remove the cable clamp screw and release the cable clamp retaining arm. Note; The cable clamp has a ratchet type mechanism on the right hand side of the retaining arm. • Loose and inappropriate connections can make the terminal overheat.
TECHNICAL DATA SUPPLY: 220 -240V ~ 50Hz 5.04kW - 8.
CUSTOMER CARE CUSTOMER CARE WEB SHOP Having purchased a superior cooker, hob or hood from us, you’ll naturally want to keep it looking great. And who better to help you care for it than the manufacturer? We offer an extensive range of accessories, components and cleaning products which, will instantly give your cooker a good as new look. range of Bake ware and Cookware essentials including Roasting Pans, Cake Tins and Non-Stick Cooking Liners. For all enquires, please visit our Web Shop at www.gdhaonline.
Please keep this handbook for future reference, or for anyone else who may use the appliance.
Please keep this handbook for future reference, or for anyone else who may use the appliance.
CUSTOMER CARE To contact Belling about your appliance, please call Warranty Registration 0844 481 0182 to register your appliance Customer Care Helpline 0844 815 3746 in case of difficulty within the UK Alternatively general, spares and service information is available from our website at www.belling.co.uk Please ensure that you have the product’s model no and serial no available when you call.
