Technical data

installation
REVERSING THE SWING OF THE
DOOR
(Note:thedoorisfactoryttedwithLH
hinging)
1. Remove the inner door glass by lifting
upwards.
2. Undo the inner glass stop securing
screws(2-off)&removetheinnerglass
stops.Note:aTORXheadscrewdriver
(sizeT10)willberequiredforthisopera-
tion.
3. Undo the screws securing the upper
hinge & remove.
4. Remove the door assembly from the
lower hinge & rotate such that the door
handle is on the left hand side. Invert
the upper hinge such that it becomes
the lower hinge on the right hand side &
fasten to the front frame ensuring that
the bearing washer from the lower hinge
onthelefthandsideisttedtoit.
5. Remove the lower hinge from the left
hand side & insert into the top of the ro-
tated door assembly. Offer up to the front
frame & secure with both screws.
6. Replace both inner glass stops into
their new positions at the bottom of
the door & secure with the TORX head
screws.
7.Rettheinnerdoorglass.
8. To enable the door to be used in either
left hand or right hand opening mode,
theappliancehasbeenttedwithroller
catches on both sides of the front frame.
DOOR BADGE
If the appliance being installed has been
supplied with a self-adhesive door badge,
thisshouldbettedtothedoorusingthe
cardboard template supplied. The badge
shouldonlybettedafterdecidingwhich
sidethedooristobehinged&re-tting,
if necessary, has been carried out. The
template should be positioned on the bot-
tom & side edges of the door glass.