Technical data

USING THE HOB
Power Level
Maximum
Operation Time
hours
1 8
2 6
3 5
4 5
5 4
6 1.5
7 1.5
8 1.5
9 1.5
P (Power Boost) Max 5mins
Energy Saving Tips
Always place cookware on the cooking
zone before it is switched on. When ever
possible place lids on pans.
TROUBLESHOOTING
The hob produces a smell the rst
few times it is used
Heat a pan full of water on each zone for
half an hour.
Pans make a noise during cooking
This is caused by vibration due to the pas-
sage of energy from the hob to the pan.
On a high setting this is quite normal for
certain types of saucepan. It will not dam-
age the hob.
The hob makes a slight clicking
sound
This is caused by the distribution of power
between two heating zones on the same
side of the hob.
The hob won’t work. The indicators
don’t come on
The electricity supply is not reaching the
appliance (faulty supply or connection);
Check the fuses and the cut-out switch.
Refer to Troubleshooting chart and if
problems persist call, the customer service
hot line for further assistance.
The fan keeps working for a few min-
utes after the hob has been turned
off
There are cooling fans tted to this
appliance which will operate when the
appliance is on and until the appliance is
sufciently cooled.
Appliance Errors Fault Description Action
ER03 and
permanent tone
Continuous button actuation; control
switches off after 10 s
Clean the user interface.
E2 Over temperature Allow system to cool
E3
1. Pot/pan not suitable, example Loss of
magnetic properties because of tempera-
ture at bottom of pot.
2. Power of cooking zones
permanently exceeded
1. This error is reset after 30 s; the cooking zone can be
used again. The pot/pan must be removed if the fault keeps
reoccurring.
2. The power unit must be replaced if the error continues to
be displayed even when no pot/pan is present on the cooking
zone.
E/H Invariable resistor fault Induction module must be cool