Installation guide

ELECTRONIC TIMER OPERATION
18
Setting the time of day
Make sure all the oven controls are
turned off.
l
Check the electricity supply to the
cooker is turned of.
l
When switched on the display will
show 00.00 and the ‘AUTO’ symbol
flashing intermittently.
l
Press and hold the Cook Period and
the End Time buttons together. Shown
in black on the diagram below.
l
Use the ‘+’ and ‘-’ buttons to select-
ed the time of day. Shown in grey on
the diagram below.
l
Release all the buttons simultaneous-
ly.
l
The time of day is now set.
To change the time of day repeat steps
4, 5 & 6 above.
Note: You cannot set the time of
day if the oven is set for an
Auto Cooking Programme.
Setting the Minute Minder
l
Ensure the time of day is set correct-
ly.
l
Press and hold the Minute Minder
button. Shown in black on the dia-
gram below.
l
With the Minute Minder button held
in, use the ‘+’ and ‘-’ buttons to set the
required duration. Shown in grey on
the diagram below
l
Release all the buttons and the timer
display will revert back to the time of
day. The bell symbol will remain lit to
signify that a Minute Minder period
has been set.
At the end of the set time an audible
tone will be heard, and the bell sym-
bol will disappear.
To cancel the Minute Minder, and stop
the audible tone press the Minute
Minder button.
Notes:
l
The remaining time can be checked
when the Minute Minder has been set,
by pressing the Minute Minder button.
l
The Minute Minder function can be
cancelled by holding the Minute
Minder button down, and pressing the
‘-’ button until the timer has counted
back to 0.00
A
U
T
O
08 27095 00- 152A CC 14/6/04 11:00 am Page 20