Technical data

Care and Cleaning
‘Cookclean’
Panels
Grill and Ovens
Rod shelves and enamel parts of the oven or grill can be cleaned using
household cream cleaner with a nylon pad or sponge. Heavier soiling
may require the use of a proprietary oven cleaner or steel wool pad,
but do not allow these to contact either the ‘Cookclean’ enamel or
any of the door seals or plastic parts of the cooker.
Only use oven cleaners which carry the Vitreous Enamel
Development Council’s Approvals symbol, and always
follow the manufacturers instructions for use.
The oven and grill side runners, and the fan oven back panel, are
coated with a special ‘Cookclean’ enamel which will absorb and
gradually vapourise any splashes which occur during cooking. The
surface coating, which can be recognised by its matt finish, may be
damaged by using aerosol oven cleaners, oven pads, detergents or
scouring powders, and their use is not recommended.
Any particularly heavy soiling or splashing may indicate the cooking
temperature has been too high, or that excess fat or water has been
used when roasting. It can be removed by ‘blotting’ the surface with
a paper towel or soft sponge, or by running the oven empty at maxi-
mum setting for about 2 hours.
Whilst normal cleaning can be carried out with these panels in place,
they can be removed for cleaning manually, or for cleaning the rest of
the oven interior. First, remove the oven shelves. The panels can then
be removed by undoing the fixing screws.
To clean these ‘Cookclean’ panels by hand, scrub them with a nylon
pad or brush, using warm soapy water. Rinse in cold water and ‘blot’
them dry with a paper towel or sponge. Do not rub the surface too
dry as this can damage the ‘Cookclean’ finish. After cleaning, replace
the panels immediately and run the oven at maximum setting for
about 30 minutes to prevent deterioration of the enamel.
Wipe with a cloth wrung out in hot soapy water.
Wash with a cloth rung out in hot soapy water. For stubborn stains
use a non-stick pad carefully. Ensure both sides are rinsed and dried
thoroughly. DO NOT put in a dishwasher.
WARNING: ISOLATE COOKER FROM SUPPLY BEFORE REPLACING
LAMP.
Open the oven door and remove the rod shelves. Use a thick cloth to
grip the light glass dome, unscrew anti-clockwise and lift out. Reach
into the aperture with thick cloth, and unscrew the faulty lamp anti-
clockwise (15W 300˚C SES). Fit replacement lamp, refit glass lens.
The oven lamp is not covered by the guarantee.
A new lamp may be obtained from our Parts Department by calling:-
01709 579907.
35
Plastic
Grill pan handle,
Control knobs
Griddle
Replacement of
Oven Lamps