Installation Guide

5
Installation (continued)
4
Removing the protective caps
□ Remove the protective caps (P). Loosen the
anges (Q) from the valve bodys (R & S). Adjust
the rubber washers (T), metal washers (U) and
mounting nuts (V) to the bottom of valve
bodys (R & S).
5
Installing the valve bodies
□ From underneath the deck, insert the cold end
valve (S) with the rubber washer (T), metal
washer (U) and mounting nut (V) through
the hole on the right (cold) side.
□ From above, thread the ange (Q) onto the
valve body (S).
□ Tighten the mounting nut (V) using a basin
wrench, so that the ange (Q) sits ush against
the nished deck surface.
Please contact [phone] for further assistance.
P
Q
R
T
U
V
P
Q
S
T
U
V
□ Repeat this procedure for the hot end valve (R)
on the left (hot) side.
S
T
U
V
Q
R
W
S
R
G
W
6
Connecting the hoses
□ Connect the hoses (W) to the bottom of the hot
and cold end valves (R & S), as shown.
□ Align the middle body (G) in a position that will
allow maximum clearance to connect the
hoses (W).
□ Carefully bend the hoses (W) to t in the
available space, and carefully thread the hose
(W) couplings onto the sides of the middle
body (G). Tighten all connections with a wrench.