Installation Guide

1.Place the spout into center hole(The hole diameter

should be 1-3/8”) of the sink.Under sink,secure ÿrmly

to sink with rubber washer(17),metal washer(16) and

nut(15).

2.Insert the valve body assembly with the hot supply

label is on the left (hot) side.Hold the body in the proper

position.Assemble metal washer(10) and mounting nut(11)

onto body underside of sink,tighten it with the locking

screws.

Faucet Installation

3.Align the blocks (1,2,3) and tabs (A,B,C) on the quick

connects (K).Push the quick connects (K) ÿrmly upward

and snap onto the blocks (1,2,3).Pull down moderately

to ensure each connection has been made.If it is

necessary to remove the X-over hose,press on the

tabs (A,B,C) and pull the quick connects (K) .

4A.Stainess steel braided faucet supply tubes:

This the simplest of all installations.If you are using

stainless steel braided faucet supply tubes,this faucet

requires one end of the supply tube to have a 1/2” female

IPS connection.The other end of this supply tube must

match the thread on the water supply ÿttings or shut o°

valve under your sink.Once you have identiÿed the

required tube,carefully follow the manufacturer's

installations instructions for each tube.

4B.Ball Nose Flexible Supplies: If you are using ball-nose

˜exible supplies to connect the faucet to water supply lines;

Slip coupling nut behind ball-nose of ˜exible supply tube.

Ball nose coupling will go partially into IPS shank or ÿtting.

Tighten coupling nut (Do Not Overtighten).

lnstall opposite end according to manufacturer's instructions

for both tubes.

3 4A

Hot

Cold