Operation Manual

GB
│
IE
│
11 ■
BMAD 550 A1
Cleaning and Care
DANGER – RISK OF ELECTRICAL SHOCK!
►
Before cleaning the appliance, disconnect the power plug from the mains
power socket! Otherwise there is the risk of electric shock!
► Never open any parts of the housing. There are no serviceable parts
whatsoever inside. When the housing is open, there is the risk of receiving
a potentially fatal electrical shock.
NEVER immerse the appliance in water or any other liquid! There is
a risk of fatal electric shock if residual liquids come into contact with
live components during operation.
WARNING – RISK OF INJURY!
► Allow the appliance to cool suffi ciently before cleaning it. Risk of burns!
CAUTION – PROPERTY DAMAGE!
Do not clean the appliance or parts of it in the dishwasher!
If you so, the appliance will be damaged beyond repair .
► Do not use abrasive or caustic cleaning agents. These can attack the
surface and damage the appliance beyond repair.
NOTE
►
Ideally, clean the appliance directly after cooling, so that milk residues
cannot dry onto it. For the fi rst rough cleaning fi ll the jug with water and
a little detergent (the whisk 3/7 used is still fi tted). Pay attention to the
MIN and MAX
markings. Start the appliance so that the whisk 3/7
swirls through the water. Afterwards, rinse the appliance out with plenty of
clean water.
For a thorough cleaning, proceed as follows:
■ Remove the whisk 3/7 from the appliance to clean it and clean the inside
of the appliance with warm water. Add a little detergent. Wipe the interior
with a soft cloth or sponge. Pay special attention to the area around the
drive shaft. Rinse out the appliance carefully with plenty of clean water.
■ Pull the sealing ring 2 off the lid 1 and clean both parts in mild soapy
water. Rinse off detergent residues with clean water and dry both parts well.
Push the sealing ring 2 back onto the lid 1.
■ Clean the whisks 3/7 in mild soapy water and then rinse them well with
clean water.
IB_277057_BMAD550A1_DK_NL.indb 11 10.05.16 13:40