Installation Guide

18
 Make sure that the DS & panels are flush on the same plane by adding more adhesive to one or
the other.
Vertical Kits-
Dry fit Back Panel aligning top of panel to line on the wall for bottom of Design Strip.
 Prior to installing the back panel, place a bead of silicone inside the channels of the internal
trims. Use 100% silicone circles on the backside of the panels about 4” in between each one (pic.
4.4). These circles will provide suction when pressed firmly to the wall. Leave 1 ½” from any side
or top that will have a trim piece applied later to it, as this will allow the backside of the trim
piece to slide behind the panel with no blockage.