Installation Guide

11
Installing the Panels & Components-
Remove the printed face of the internal trim from the internal base (Pic 3). Then dry fit both printed face
and base to make sure the internal trims are cut 3/8” lower than the top of the wall allowing the (2)
external trims to meet together on the inside corner.
Pic. 3
Apply the internal base into the corner using silicone & hot glue by starting at the bottom and moving
upwards (pic. 3.1), The hot glue will hold the piece in place while the silicone sets up.
You can also use a staple gun (pic. 3.2) , just make sure all of the staples are flush with the plastic or they
will interfere with the panel fitting inside the internal trim piece.
Pic. 3.1 Pic 3.2