Installation Guide

1/2" (12,7mm)

Plastic Round Lampholder Cover

Wet Location

Includes closure plugs, gasket and screws.

Cubierta Redondo de

Portalámpara Plastico

Lugar Húmedo

Incluye tapones de cierre, empaquetadura y tornillos.

Holes

Oricios

Instructions on back

Instrucciones al dorso

A Division of Hubbell Incorporated (Delaware)

800-526-5416

www.TayMac.com

PLV330_CS_MC_REV-B

Designed in USA /

Disenado en los USA

Made in China /

Hecho en China

White

Blanco

PLV330WH

PAGE 1
3 Holes Orificios 1/2" (12,7mm) Plastic Round Lampholder Cover Wet Location Includes closure plugs, gasket and screws. Cubierta Redondo de Portalámpara Plastico Lugar Húmedo Incluye tapones de cierre, empaquetadura y tornillos. White Blanco Instructions on back Instrucciones al dorso PLV330WH Designed in USA / Disenado en los USA Made in China / Hecho en China A Division of Hubbell Incorporated (Delaware) 800-526-5416 www.TayMac.
PAGE 2
Caution: Turn off Power 1. Install in accordance with local electrical codes. 2. Thread lamp holders into cover, coating threads with sealing compound. 3. Aim Lamp holders to desired angle and tighten. 4. Wire the lamp holders to the supply lines in the box, white to white (neutral) and black to black (hot). 5. Attach cover to the box, centering the gasket using supplied hardware. 6. Close all unused holes with closure plugs. 7. Seal all openings to comply with wet location installation.