Installation Guide

CONFIGURING THE BASE • CONFIGURACIÓN DE LA BASE

Already GFCI Congure for Duplex Congure for Adapter

Viene GFCI Congure para Doble Congure para el Adaptador

1 1 2 1 2

Comes pre-configured for

GFCI.

Slide in duplex adapter to

the back of the base.

Configured for duplex.

Break out round pieces on

both sides for switch/round

adapter.

Configure adapter then snap

it to the back of base.

Viene pre-configurado para

GFCI.

Deslice el adaptador dúplex

a la espalda de la base.

Configurado para doble. Cortar hacia afuera

los pedazos redondos en

ambos lados para el adap-

tador interruptor/redondo.

Configure el adaptador y

luego colóquelo a presión

en la parte posterior de la

base.

MX1250_NS_HD_REV-B

PAGE 1
CONFIGURING THE BASE • CONFIGURACIÓN DE LA BASE Already GFCI Viene GFCI Configure for Duplex Configure para Doble 2 Configure for Adapter Configure para el Adaptador 1 1 Comes pre-configured for GFCI. Slide in duplex adapter to Configured for duplex. the back of the base. Break out round pieces on both sides for switch/round adapter. Configure adapter then snap it to the back of base. Viene pre-configurado para GFCI. Deslice el adaptador dúplex a la espalda de la base.
PAGE 2
INSTALL UNIT • PARA INSTALAR LA UNIDAD MX1250 IMPORTANT: Turn off power to outlet. IMPORTANTE: Desconecte el suministro eléctrico hacia el receptáculo. Turn off power to receptacle. Configure base as shown on other side. Back-out box screws. (Note: Make sure that box is flush or slightly behind the finished surface and that receptacle is flush with the finished surface in accordance with NEC 406.4 and 314.20.) Place gasket over the screws. Using keyholes, place base over screws and against gasket.