Specifications
Table Of Contents
- TABLE OF CONTENTS
- Introduction
- Basic System Operation
- Panel Controls
- Number and Letter Buttons
- Call sequence
- Silent viewing
- Apartment Station Controls
- Auto Display
- Ringer Mute
- Door Status Indication
- Call Privacy
- User Activation (CCTV Mode)
- Cameras
- Extension Apartment Stations
- Lock Type
- Exit Button and Fire Switch
- Trades Facility
- DDA Functionality
- Multiple Entrances
- Gate and Block Systems
- Design Considerations
- Installation & Commissioning
- Checklist
- Wiring
- Commissioning
- BFD-DIG Door Controller Settings
- Security
- Panel Programming
- ACOD – Primary Access Code
- TCOD – Secondary Access Code or Tradesmen’s Code
- LTIM – Lock Release Operating Time
- LOCK – Lock Type
- CAM2 – Second Camera Present?
- TRAD – Door Button Trades Mode
- DMON – Door Status Switch
- RECP – Reception Phone Address
- PSEC – Panel Security Key
- PPRG – Phone Programming Security Key
- RING – Ringing Time/Call Time and Ring Effect
- TALK – Talking Time/Apartment Station Active
- TONE – Re-assurance Tone
- CANC – Cancel Key Compatibility
- BCAL – Bellcall Compatibility Mode
- 12A? – Flat 13 Numbered as 12A (From build 4)
- BFD-DIG Door Controller Jumper Settings
- BSC4 Video Controller Settings
- BF Apartment Station Switch Settings
- BS Videophone Switch Settings
- ATTENTION
- Troubleshooting
- Specifications
- Diagram A – Basic System Wiring Overview
- Diagram B – BFD_DIG PCB Detail
- Diagram C – BFD-DIG Keypad Matrix
- Diagram D – Basic System Wiring Detail
- Diagram E – BSC4 PCB Detail
- Diagram F – BSC4 Wiring Detail
- Diagram G – Large system Overview
- Diagram H – Extension Apartment Station Wiring
- Diagram I – Apartment Station Local Power Wiring
- Diagram J – Camera Sharing & Time Clock Sharing
- Diagram K – Combined Connections bellfree With Lock
- Diagram L – Combined Connections Third Party Lock
- Safety Information and Declarations
BF Apartment Station Digital Entry System
PD–166 Issue 1 Installation and Operating Manual Page 44 of 48
Diagram L – Combined Connections Third Party Lock
Connecting a Bell PAX1 Proximity Reader
The bellfree door controller is set to fail secure. The diagram assumes a common
power supply, if not an extra wire will be required to connect the PAX1 Exit O to the
bellfree 12V-.
N.B. The power wiring to the PAX1 must be able to carry the lock current with less
than 2V voltage drop.
ACT 1000/2000/3000 Proximity Controller or 100e/200e Extender
Notes
1. Connect the lock release or Maglock using the ACT Manuals.
2. Leave the bellfree controller set to Fail Secure regardless of the type of release used.
3. A normally open exit button can still be fitted to the ACT controller in addition to the
bellfree wiring.
4. If the 2 units are not sharing a power supply, then a connection from bellfree controller
Exit- to ACT 0V will be required.
5. Look for the notes on the ACT installation diagram concerning the use of links when
the door contact is not used and when a power supply without power fail is not used.
bellfree
Door
Controller
bellfree
Door
Controller
PAX1
Proximity
Reader
Exit button
(Optional)
Exit Z
Exit O
Z
O
+
–
Lock
–
Exit button
(Optional)
Supply
IP3
IP2
IP1
0V
OP2
OP3
Lock
+
–
ACT
Push button
Door contact
Aux input
–
Exit