Installation guide

Upgrade of original 46 cm Satellite dish with new 51cm

Multi-Satellite dish

12. Detach the LNBF from the Y-adapter and disconnect the coaxial cable.

Thread the cable through the satellite dish arm so that it protrudes through

the opening of the Y-adapter labeled 82°.

13. Connect end of coaxial cable to the new LNBF that was packed in your

Upgrade Kit. Attach the LNBF to the Y-adapter and secure it with the LNBF

screw and bolt.

Mast

Y-Bracket

14. Using the ‘Point Dish’ screen, confirm that a signal is being received by the

satellite dish. On the ‘Single Satellite’ screen you will see a message indicating

‘Wrong satellite!’ which is perfectly acceptable. On the ‘Dual Satellite’ screen

select ‘Bell ExpressVu 82’ to indicate the signal strength.

You have now completed the ‘Dish Upgrade’ and can now proceed to the

‘Wiring Upgrade’:

• If you are wiring your satellite system for up to two receivers,

go to page 11

• If you are wiring your satellite system for three-to-four receivers,

go to page 13

Upgrading current 51 cm Multi-Satellite dish with

second LNBF

The components in your Upgrade Kit which will you use in this section are:

– one LNBF (low noise amplifier)

To upgrade your 51 cm Multi-Satellite Antenna Dish to enable it to receive

two satellite signals, you must perform the following steps:

1. Remove expansion slot cover on the Y-adapter located at the end of the

satellite dish arm.

2. Detach the LNBF from the Y-adapter and disconnect the coaxial cable.

Thread the cable through the satellite dish arm so that it protrudes through

the opening of the Y-adapter labeled 82°.

3. Connect end of coaxial cable to the new LNBF that was packed in your

Upgrade Kit. Attach the LNBF to the Y-adapter and secure it with the LNBF

screw and bolt.

Y-Bracket

Dish UpgradeDish Upgrade