Replacement Parts List
PARTS LIST CP207J-PL (CONTINUED) SERIES 1510 PUMPS
How to use this
PARTS LIST
T
he pump nameplate identifies the pump by pipe size, pump construction and impeller
diameter as shown below. Pumps manufactured in 2001 and before have a name-
plate similiar to the nameplate below left. Pumps manufactured in 2001 and after have a
nameplate similiar to the one below right. Although the nameplates look different,
they each display the same information.
The nameplates above identify the pump in the example as a Series 1510, size 5G in
bronze fitted (BF) construction. The impeller diameter is 12
3
/4", and the motor is 50 hp,
1750 RPM. The serial number specifically identifies the unit for future reference. DO
NOT REMOVE THE NAMEPLATE. It is important when ordering replacement parts to
furnish complete nameplate data.
The 1510 pump is furnished with both “Standard Seal” or “Stuffing Box” configura-
tion. The “Standard Seal” pump has no seal designation after the Series number on
the nameplate. If the example pump was of “Stuffing Box” configuration, the name-
plate would show it to be a 1510-S, 1510-PF or 1510-D pump. Parts for “Stuffing
Box” type pumps are covered under the CP-206E-PL parts list.
To ensure the correct parts are selected, use the following procedure:
1. Determine from the nameplate the pump size, seal configuration, pump construc-
tion and impeller diameter.
2. Measure shaft sleeve diameter at the seal.
3. Refer to the index for the page number of the parts breakdown for the specific size
pump.
4. Find the proper column in the parts breakdown for the pump construction involved.
5. Select part numbers using the numbered drawings on page 4 for identification.
Where shaft diameter affects parts selection, use the measurement secured in
Step 2.
6. Bearing frames vary with motor frame sizes. Use the motor frame number (found
on the motor nameplate) to select the proper bearing frame from the chart on
page 5.
3
S
ize
S
ize
S
eries
Flow
Head
H
P
RPM
Impeller
Diameter
Pump
Construction
S
erial
N
umber
Construction
Serial No.
S
eries
F
low
H
ead
H
P
R
PM
I
mpeller
D
iameter
Date Manu-
factured
(October,
1988)
Date Manufactured
(February, 2008)
Bell & Gossett
ITT Industries
SIZE
MOD.
GPM
FT.
HP.
RPM
SERIAL
N
O.
MX. W.P
.
PSI.
MORTON GROVE, IL USA
1510BF 12.15
5G
B80CL2396 – 02
175
1800
50
150
990
Bell & Gossett
ITT Industries
SIZE
MOD.
GPM
FT.
HP.
RPM
SERIAL
N
O.
MX. W.P
.
PSI.
MORTON GROVE, IL USA
1510 BF 12.15
5G
B80CL2396 – 02
175
1800
50
150
990