Owner manual

Xylem Inc.
8200 N. Austin Avenue
Morton Grove, Illinois 60053
Phone: [phone]
Fax: [phone]
www.xyleminc.com/brands/bellgossett
Bell & Gossett is a trademark of Xylem Inc. or one of its subsidiaries.
© 2013 Xylem Inc. DN0178B July 2013
TROUBLE SHOOTING
SYMPTOM PROBLEM SOLUTION
Pump will not start Incoming power not connected. Connect incoming Power.
Float control not “Made”. Operate system to “Make” Float Control.
Pump “ON-OFF” Switch not ON. Turn ON switch.
Fuse Blown. Replace fuse per label in enclosure.
Pump runs but light doesn’t light Blown pilot light. Replace pilot light.
DEALER SERVICING
If trouble occurs that cannot be rectified, contact your local
B&G representative. He will need the following information
in order to give you assistance.
1. Complete nameplate data of panel.
2. Voltage, phase, and FLA of motor.
3. Actual ampere draw of motor.