Manual

BELL&GOSSETT

INSTRUCTIONMANUAL

A07209

REVISIONC

IsolationFlange

OperationalLimits

MaxTemperature 250°F(121°C)

MaxPressure 150psig(10Bar)

INSTALLER: PLEASELEAVETHISMANUALFORTHEOWNER’SUSE.

SAFETY



INSTRUCTION

Thissafetyalertsymbolwillbeusedinthismanualtodrawattentiontosafetyrelated

instructions.Whenused,thesafetyalertsymbolmeansATTENTION!BECOMEALERT!

YOURSAFETYISINVOLVED!FAILURETOFOLLOWTHESEINSTRUCTIONSMAY

RESULTINASAFETYHAZARD.

DESCRIPTION

TheIsolationFlange(IF)isacombinationofanisolationvalveandacompanionflange

forcirculators.Theisolationflangeallowseasyserviceorreplacementofthecirculator

withouttheneedtodrainthesystem.

INSTALLATIONINSTRUCTIONS

1. InstalloneIFonthesuctionsideofthehydroniccirculatorandoneonthedischargeside.

2. Seethefollowinginstallationinstructionsanddrawingsforadditionalinformation.

3. Applytorquein even incrementstobothflangebolts.Refertothepumpmanufac-

turersinstruction manual fortorque value.Both the suctionand dischargeflanges

mustbetorquedinthismanner.

WARNING:Systemfluidsundertemperatureorpressurecanbehazardous.

Be sure the pressure is relieved and system temperature is below 100°F

(38°C). Failure to follow these instructions could result in property damage and/or

personalinjury.

WARNING:Topreventleakage,makecertainthattheflangeboltshavebeen

adequately torqued. Failure to follow these instructions could result in

personalinjuryand/orpropertydamage.

CAUTION:Over-tightening and breakage can occur with the use of teflon

pipe joint compounds. Teflon provides lubricity so that care must be

exercisednottoover-tightenjoints.Failuretofollowtheseinstructionscouldresultin

propertydamageand/orpersonalinjury.

ForNPT connections:

a) Applypipecompoundconservativelytothemaleconnectingfittingsonly.

b) UponcompletionofIFinstallationtopiping,checkconnectionsforleaks.

www.bellgossett.com

NOTE:Thisproductisnotintendedforuseinpotablewaterapp

lications.

WARNING:California Proposition 65 Warning! This product contains chemicals known

to the State of California to cause cancer and birth defects or other reproductive harm.

PAGE 1
BELL & GOSSETT INSTRUCTION MANUAL A07209 REVISION C Isolation Flange Operational Limits Max Temperature Max Pressure 250°F (121°C) 150psig (10 Bar) INSTALLER: PLEASE LEAVE THIS MANUAL FOR THE OWNER’S USE. NOTE: This product is not intended for use in potable water applications. WARNING: California Proposition 65 Warning! This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.
PAGE 2
For Sweat connections: a) Clean tube ends and IF connections thoroughly per good piping practices with a fine grade emery cloth or fine grit sandpaper. b) For soldering, use 95-5 (Tin-Antimony) solder and a good grade of flux. c) Use a torch with a sharp pointed flame. d) When sweating joints, first wrap the IF body with a cool wet rag, then direct the flame with care to avoid subjecting the IF valve to excessive heat. Allow the IF to cool before touching or operating.