Instruction Manual

TECHNOFORCE Installation, Operation, and Maintenance
30
4.10.26 Load from ash
The Load From Flash screen is displayed below:
LOAD FROM FLASH
All Settings will be
Overwritten!
PROCEED: $ (Y/N)
Press YES/7 and ENTER to overwrite all of the current user setup information with the data that was
previously saved to the ash memory. Loading from ash memory will load all setup information that was saved
to the Flash PROM chip within the controller.
4.10 27 Load default
The Load Default screen is displayed below:
LOAD DEFAULTS
Settings will be
Overwritten by the
defaults! PROCEED:$(Y/N)
Press YES/7 and ENTER to overwrite all of the current user setup information with the factory defaults.
4.10.28 Display menu
Paths: Status Screens / Set up(3) / System(3) / Display(13)
The DISPLAY menu has been shown below:
Delay to Display
Status # m
Rate ##s Exit $(Y/N)
Press the next ( ) key to go to the next screen. The display now shows:
<Backlight
Off Tmr: ###m
Exit $ (Y/N)
To edit the values, press the NO/0 key and ENTER key. Modify the values as desired.
See following table for all DISPLAY menu items.
Display Menu Items
Menu Item Variable Default Range Field
Value
Display Delay to Display Status: ## 3 0-99
The time in minutes after which the fourth line at initial
system status screen will start showing system status if
any key has not been pressed
Status Line Refresh Rate: ## 10 0-99
The time in seconds prior to change the next system
status line
The time in minutes after which the backlight display 60 0-999
will turn off if a key has not been pressed. A value of 0
displays this function.
Installation
▲