User manual

P75598- Belkin OmniView Serial Console
Network > IP Config
The following page shows the IP configuration items.
1. For IP mode -- you can press SPACE bar to select Static mode or DHCP mode.
2. For IP Address, Subnet mask, Default Gateway, Primary DNS, and Secondary
DNS -- you can change these network settings.
3. After changing the settings, the final enter, the Serial Console will prompt to confirm
YES or NO. If select YES, the Serial Console will reboot and save the settings into the
Flash memory.
Network > Current IP
To show the current network settings.
Network > IP Filter
To enable/disable IP filter function.
System > Reboot
To reboot the Serial Console
System > Reset to Default
To reset configuration to Factory Default Settings.
Note: Only the admin user has the privilege to perform this function.
System > Status
To show the system status.
S-to-S > Select Serial to Serial port
To configure an internal serial port-to-serial port connection. The last serial port or internal
port can be configured. Refer to section ___ Serial-to-Serial Function for more details.
19 / 66