User manual

76
Overview
76 76
Antennas
RJ45 Ethernet
Jack
Powe
r Jack
Reset button
Power Jack
Connect the included 5V DC power supply to this jack.
RJ45 Ethernet Jack
Connect an Ethernet cable to this socket, and connect to an open RJ45
10Base-T or 100Base-Tx port on a switch, hub, or WRE/AP.
Reset Button
The “Reset” button is to be used in the unlikely event that your WRE/AP
malfunctions. Resetting the WRE/AP restores its normal operation while
maintaining the programmed settings. You can also restore the factory
default settings by using the Reset button. Use the restore option if, for
example, you have forgotten your password.
a. Resetting the WRE/AP
Push and release the Reset button. The lights on the WRE/AP will
momentarily flash. The Power/Ready light will begin to blink. When
the Power/Ready light becomes solid again, the reset is complete.
b. Restoring the Factory Defaults
Press and hold the Reset button for 10 seconds, then release it.
The lights on the WRE/AP will momentarily flash. The Power/Ready
light will begin to blink. When the Power/Ready light becomes solid
again, the restore is complete.
Rotatable Dual Dipole Antennas
Two unidirectional dipole antennas are located on the side of the WRE/AP.
The antennas can rotate 180 degrees. The antennas should be oriented in
the vertical position for best performance.
LAN
DC 5V/2.0A