User manual

4342

Power LED does not come ON; Access Point is not working

Check your physical connections. If the LED indicators do not light,

the Wireless Range Extender/Access Point (WRE/AP) may not be

connected properly.

Verify that the WRE/AP is plugged into a power source. Check to see

that the cables are connected to the correct ports and that they are

secure.

Wireless Range Extender Mode is not working

If the Wireless Range Extender Mode on the WRE/AP is not working, it

could be that the WRE/AP is not correctly configured to broadcast to

the Belkin Wireless Router.

In the WRE/AP Web-Based Advanced User Interface (see “Configuring

WRE/AP as a Wireless Range Extender” section of this manual), check

to see that the WRE/AP is in Wireless Range Extender Mode and it is

connecting to your Belkin Wireless Router by verifying that the correct

MAC address is entered. Using a PC, ping “192.168.2.1” (the Router’s

default IP address) to check that a connection has been established

between the WRE/AP and the Router.

Note: The WRE/AP can be configured to extend the range of the Belkin

Wireless Router and is not guaranteed to be compatible with other

manufacturers’ devices.

I can’t connect to the Internet wirelessly

If you are unable to connect to the Internet from a wireless computer,

please check the following items:

1. Look at the lights on your Wireless Router. If you’re using a

Belkin Wireless Router, the lights should be as follows:

• The “Power” light should be on.

• The “Connected” light should be on, and not blinking.

• The “WAN” light should be either on or blinking.

Troubleshooting