User manual

section
1
2
3
4
5
6
7
17
In order to access the Web-based User interface, you must first set
your computer to the same IP address range as your Wireless G Range
Extender/Access Point.
Windows 98SE, Me, 2000, and XP
1.
Go to the Windows Control Panel and double-click on the Network
icon or the Network Connections icon.
2. Right-click on the Local Area Connection for your wireless adapter
and select “Properties”.
3. In the General tab, select the Internet Protocol TCP/IP settings for
your wireless adapter and click on the Properties button.
4. Select the “Use the following IP address” radio button.
5. Enter an IP address in the same subnet as the access point (for
example, 192.168.2.200).
6. Enter the following subnet mask: 255.255.255.0 then click “OK”.
Note: Once you have completed configuring your WRE/AP, repeat steps
1 through 3. Then select “Obtain an IP automatically” or set a valid IP for
your computer on the same subnet as the network you are connecting to.
Using the Web-Based User Interface